How to establish a Flare connection?
Flared fittings do not require pipe paste or Teflon tape. The fitting is sealed by compressing a flared tube (usually made of a soft material such as copper) and connecting it.
What is used to make a flared fixture?
Flared fittings are a type of compression fitting used with metal pipe, typically mild steel, wrought (soft) copper, and aluminum, although other materials are also used. Pipe expanding is a form of forging and is generally a cold working process.
How is the flaring of pipes done?
Flared Outlets:
It is placed along the diameter of the tube towards the end in a hole corresponding to the tube of that size, with a sleeve forming a sleeve. After clamping, another tool is used that deforms the tube as it is screwed in, creating an expansion or contraction at the end.
How do flared fittings work?
The nut draws the flare tube into a properly shaped fitting, creating an extremely strong connection. In residential applications, flared fittings are used with soft copper tubing for gas and oil pipelines.
How to establish a Flare connection?
Flared fittings are a type of compression fitting used with metal pipe, typically mild steel, wrought (soft) copper, and aluminum, although other materials are also used. Pipe expanding is a form of forging and is generally a cold working process.
What is used to make a flared fixture?
To flare the tubing, place it in the hole that matches the copper size of the flare. Place the reamer in the flared mold so that the taper is against the tube. As the reamer is tightened, the tapered tip slightly expands the copper.
How are water pipes widened?
Flared fittings are a type of compression fitting used with metal pipe, typically mild steel, wrought (soft) copper, and aluminum, although other materials are also used. Pipe expanding is a form of forging and is generally a cold working process.
What are flared fittings used for?
Flared outlets are used for gas pipelines and high pressure lines where even a small leak can cause big problems if left unattended.
How to seal a flared threaded connection?
Leaks in flared fittings are typically caused by misalignment, surface damage, and field vibration. Entire joint is coated with Loctite™ Baked Sealant. … And unlike ORFS fittings, the Flaretite seal does not fail in the event of a fire, allowing sprayed hydraulic oil to fuel the fire.
Do you use pipe sealant for flared fittings?
Do not use Teflon® tape or pipe sealant on flared ends or you will not get a tight seal. Keep the flared end of the fitting free of grease, oil, and thread sealant. Use the wrench only on hexagonal connection surfaces. tighten if a leak is detected.
What is a Union Flare adapter?
Torch connection 1/2″ OD x 1/2″ OD. For use in fuel, oil, liquefied and gas lines and systems. It can be connected to aluminum, copper, brass and welded steel tubes, which can be expanded. Machined solid brass body. Recommended for pressures higher than those for which the compression fittings are designed.